Hôm nay mở thùng ra, bắt đầu vọc
1) Download Firmware & Software. Post #7
http://forum.tkaraoke.co...-x32-rack.aspx#post64201Bắt đầu đọc nguyên cả thread này .... Sau đó mới tính tới bước thứ 2,3,4, .....http://forum.tkaraoke.co...Mixer-X32.aspx#post543932) Update Firmware
Quote:Updates: The X32 RACK firmware can easily be updated by performing the following steps:
Download the new console firmware from the X32 RACK product page onto the root level of a USB thumb drive
Plug the USB thumb drive into the front panel USB connector while the console is turned off
Hold the USB button depressed while switching the console on. While booting, the X32 will run a fully automatic firmware update, which will take 2-3 minutes longer than the regular boot sequence
When no update file is available on the USB drive, or when it is corrupted, the update mode will remain active, preventing the X32 RACK from booting regularly. Switch the console off and back on without holding the USB button to boot the console with the existing firmware.
3)Initialize X32 (For Firmware 2.10)
Quote:1. Push Setup button.
2. Select "Global" Tab.
3. Under Initialization, turn knob to change to "console" and push the knob in.
3. Push right button to confirm.
4)Set up IP Address
Quote:1) Turn the left knob to select "IP".
2) Turn the next 4 knobs to set the IP Address. You got to assign a unique IP for your X32 based on "Your Router" setting (i.e. 192.168.1.222).
3) Turn the left knob again to select "Mask".
4) Turn the next 4 knobs to set the subnet Mask (i.e. 255.255.255.0).
5) Turn the left knob again to select "Gtwy".
6) Turn the next 4 knobs to set the "Gateway" IP (i.e. 192.168.1.1).
5) Chôm cái "Scene" của HT ở post #1 để bắt đầu cuộc chơi ... Sau đó sẽ tính tới
Quote:connect :
PC USB ====> X32
OUT 7&8 ===> EV 115P SPEAKER2
OUT 3&4 ===> RECEIVER POLKaudio SUROUND SOUND SYSTEM
CHANEL 1 ===> LINE6 XD-V75
CHANEL 2 ==> MO5 MIC
CHANEL 3 ==> MXL 3000 CONDENCER MIC
http://forum.tkaraoke.co...Recording.aspx#post637106) At TKaraoke PC, Execute driver installation file "BEHRINGER_X-USB_DriverSetup_v2.23.0".
7) Connect all hardware as described in step 5.
Voila, my basic set up is operational ... Will tweak it later
Edited by user Friday, April 03, 2015 3:28:34 PM(UTC)
| Reason: Not specified